Want to paint your windows? Staining window is a difficult project, but with patience and proper training, you can get the desired results.
Start working in a clean and dust free. Start cleaning the glass with glass cleaner and a lint-free cloth, working from top to bottom. It is important to get the window exceptionally clean for the best finish.
Then remove some of the vehicle that will hinder your work space. Remove the door panels and the tissues and rubber door seals. These can now be connected to the door panels. Once these are removed, clean all areas of the glass is not clean. If you are lucky to have a tail, remove the rear door for easy installation.
Start with the rear window first. It is always difficult to do because space is limited and its shape. Many rear windows have made them a curve which is very difficult to cover properly. We will overcome this problem by creating our model tinted film on the outside of the window. If you removed the tailgate, it is not necessary. Put a couple of bands no longer rear window overlapping the edges. Carefully cut the outer shape of the rear window as perfect as possible, ensuring that the radius (or round) sharp edges. You can do this by placing a coin in the corner and sculpture around it. Radius edges tend to not peel as easily as a sharp edge.
When the module is to cut out the back window, you can transfer the film inside the car. Spray a glass window film solution and applied to pieces exactly as it was outside the car, when the edges of the pieces overlap a little ‘. Cone of air bubbles and the solution of the film, which begins in the middle of the central part, and work your way outward. Then, move up, and work from the top down and watch the rubber squeegee the air, and the solution overlapping seams.
Once the film is applied and all the solutions and air bubbles were removed, take an exacto knife or razor blade and cut the pieces that overlap, where they overlap. You can be sure to get a straight cut with a straight edge as a rule. Be careful not to cut the rear defogger child when you do. If done correctly, this method will give a clear window behind the research. They can return to the squeegee or cloth and (also) to the area again for the softness. Clean with a lint-free cloth.
Other windows are a little ‘easier than the rear window. To create a model of these windows, cutting the window form from the freezer paper or wax paper. Take the pattern and cut the exact shape of the windows open, and apply the tint of the window first, it is definitely radius edges.
Tint window is a relatively inexpensive, so if you mess up a sheet, or cut, replace it. The finished product looks as good as the effort you put into it.